Bob’s Machine Shop Combo nose cone kit ‐ Single hose

Description
The Combo cone is our most popular sport fisher model. It has 5 inlets on the bottom of the bullet, and 4 holes above the bullet. The intakes “suck” where you put them, so if in shallow water you can block the lower ones, but the top will always remain open. Once you get up and moving again the lower will flush out and be fine. If you need a recommendation for which style of nose cone is right for you, please give us a call or email.

If you are using a smaller motor or the Mercury Inline gear case, please choose the ‘inline’ option, it is a shorter unit. Rule of thumb is any engines 90 hp or smaller need the inline kit. If you are smaller than 60hp, please call first, as the cone will require modification to work, and you might perfer to send in for factory installation.

50% more cooling capacity

Higher speed & proper water pressure

Low water pick-up

50% more volume than any now on the market.

Nose cone kit contains all hardware for complete installation

Kit comes complete with ALMAG-35 top grade casting, epoxy, hose fittings and instructions.

Crescent shaped for superior and handling

Five inlets create less chance of stoppage than anything now on the market.

Proven Quality
The same superior design as our World Speed Record Holding Big Foot, low water pick-up cones.

High Water Flow Capacity
Allow surface Piercing props (choppers, cleaver style) to be run at maximum height for top speed and all out performance, while maintaining proper cooling to engine.

Shallow Water Access
Travel and fish waters, until now, were unable to be reaches with outboard motors having standard (side water pick-up) gear cases.

Nose cone test by Bass & Walleye Magazine :

Nose Cone Shootout

Test Results and Fact Sheet

SPEED INCREASE OVER 5 MPH ON A 150 H.P. !!!